Got to get the manual out n take a few pictures of Model Info. And the unit itself- probably gonna stand behind it as a parts unit to sell as is. I bought to invest a little time pulling n reseating boards after a little pencil eraser n alcohol cleaning, and grease, oil ways, n give it a test run.
Probably to do some mist assisted closed cabinet carb spacer stuff, shock stops, n shifter handles knobs, gauge dash cutouts in light plastic or thin alum for in some old dirt car interiors.
I haven't cut power on to the building where it's stored, so can't say or use it much. Cool looking, probably serial port laptop attachable, but may not be. Small job machine, may be limited to internal ram, idk yet, just wanted to surf it out there, and if no responses, I'll fix er up n make some things.
I need a few old bmod dirt chassis' to copy rear clip mounting points to convert my ump cars down from birdcages, Chevelle n metric both, some new rules, books n tips, on both, engine parts to make em throw a dirt rooster tail while putting down some power. I would love a plasma cut kit, to make some rear end rear of cover support to stiffen the blows, and upper control arm weld on mounts, n lot's of other wishlist stuff. Ooh, a 3 phase generator to get power on n run some stuff at shop back building. I may get it all running, sell it. All at 3ook, n go racin with all y all, been Awhile, Thanks In Advance