Originally Posted by hammertime
Originally Posted by vega34
Originally Posted by hammertime
How high you want to zing the motor ?
What brand of conv and is it a sprag or spragless ?
ptc 5800 converter,not sure if sprag or not,,,,6800 would be just about it on the motor,,thanks steve
Do you know what the stall flash is and the recovery after shift ?
I think 4:88 is to much, I used to run a 355 sbc that'd go 5.40s with a 4:10 gear and 60ft 1.15-6 no issue, took me 3 converter changes to get there though.
the guy who built my trans and converter says its not the trans or converter,go figure,,everyone else says it is not my motor,,so the guy that built my trans has a 456 gear that was only run one week at pinks,so i'm buying it for $150 and trying it,,i'm still saying it could be a tight converter,,,steve