kod99

I was wondering what you guys with dragsters use to attach your motor mount plates to the frame rail? Mine are attached with srew clamps. Are they strong enough or should I chage them out to something else?
Thanks

TheYellaBrick

:shock: :shock: :shock: :shock: do you mean HOSE Clamps ? :shock: :shock: :shock:

mopar1968

I hope not Double-D the engine will pass the rail :lol: :lol: :lol:


''JUST MY TWO CENT'S WORTH''

http://www.racingjunk.com/profile/163312

fla1976

Sure hope you don't mean hose clamps! Are you using actual mounts or a motor plate. If you are using mounts , I'd go to plates. I would weld the brackets for the plates.

THERATTLER

MY MID PLATE IS BOLTED TO TABS THAT ARE WELDED TO THE FRAME , THE FRONT MOTOR PLATES ARE BOLTED TO SADDLES THAT SIT ON TOP OF FRAME WITH BAND CLAMPS AROUND THEM , NOT WORM DRIVE HOSE CLAMPS...THEN I HAVE ENGINE LIMITERS THAT BOLT TO TABS ON THE FRAME AND THE MOTOR MOUNT HOLES IN BLOCK TO STOP BACK AND FORTH MOVEMENT...

Tod74

These pics are from HAMMERTIME'S Page....

THERATTLER

THATS THE WAY MINE ARE....EVERY DRAGSTER I HAVE EVER SEEN IS THIS WAY IN ONE FORM OR ANOTHER..ONLY THE MID PLATE IS ACTUALLY BOLTED TO FRAME..I HAVE A BAND CLAMP ON FRONT PLATE SADDLE , NOT HOSE CLAMPS..THERE IS A BIG DIFFERENCE...

mopar1968

Hey Double D i understand the clamp thing now, must be a ''CHEBBY'' don't have enough power to break them :!: :!: :lol: :lol: :lol:


''JUST MY TWO CENT'S WORTH''

http://www.racingjunk.com/profile/163312

suicidebomb

Maniac is spot on, and the clamps are called t-bar clamps. Funny car engines are put in the car this very way, they hold the engines in them...Well, most of the time.

kod99

Thanks guys.
My mid-plate is bolted to the frame rails but I will change the front worm type clamps to 'T-bar' clamps. The worm type clamps didn't look strong enough. That's why I asked you experts!