S 10 fiberglass rear roll pan with wheelie bar cut out
11-23-2013, 06:33 AM
#1
Senior Member
DYNO OPERATOR
Thread Starter
Join Date: Jan 2004
Location: central Illinois
Posts: 459
S 10 fiberglass rear roll pan with wheelie bar cut out
Looking for a rear roll pan for a 1997 S 10 that is fiberglass and already has the cut out for wheelie bars in it.
Don't have wheelie bars, but the truck sets so low have to roll up on boards to put a jack underneath it in the rear.
Anyone know who sells them?
Don't have wheelie bars, but the truck sets so low have to roll up on boards to put a jack underneath it in the rear.
Anyone know who sells them?
11-26-2013, 11:51 PM
#2
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
Mark have you looked at the S10/Sonoma stepside rear bumper cover. it's eith fiberglass or rubber, i have a Sonoma shortbed stepside, prostreet truck in process. You could cut out the lic plate section and move it out to fit the regular bed i think. I don't remember if it fiberglass or rubber, but i could a pic and post it or send it to PM to see if it would soluve your problem.
Zip.
Zip.
