guide plates
05-04-2008, 08:01 AM
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Jul 2003
Posts: 6
guide plates
i just got my new pushrods but the problom is that i ordered 3/8 and my heads came with guide plates for 5/16 can i grind on these to open them up so my 3/8 pushrods go through them?or is that unsafe to do
05-04-2008, 11:18 AM
#2
Senior Member
RACING JUNKIE
Join Date: Mar 2003
Location: Fountain,MICHIGAN
Posts: 856
G/Plates
My OPINION?
Just Purchase the CORRECT G/Plates!
You have to remember,they are riding on the Push-Rods?If the motor was only turning a few Hiundred R's?You MIGHT be OK????
I would think 40.00 would Fix the Problem.........?
Later
G 8)
Just Purchase the CORRECT G/Plates!
You have to remember,they are riding on the Push-Rods?If the motor was only turning a few Hiundred R's?You MIGHT be OK????
I would think 40.00 would Fix the Problem.........?
Later
G 8)
