RonHarris68

I am sure this has been brought up on here before, but need to ask one more time.. I would like to have a low oil pressure light as well as low oil pressure safety cutoff for ignition and was wondering if anyone has recommendation as to what switch and a diagram if possible of setup.
This is for drag race application.
Thanks in advance..

Ron
[email protected]

fla1976

Here are a couple links that should help. Save the diagram to "Paint brush" or similar program and resize it and print it out. The other link is for a 12 Lb switch. The momentary switch is for easier starting. I would leave out the oil pressure switch that follows the fuel pressure switch.

http://www.smileysracing.com/shoppin...i=60723&c=1730

https://encrypted-tbn2.gstatic.com/i...bCtPGqbyi1G5vs

RonHarris68

Thanks RacingJunkie for the reply... Is there a three connection type pressure switch on the market that will illuminate the idiot light with no or low pressure and an ignition cut out if falls around 15 PSI? Asking a lot but before I plumb in and wire two separate switches, just want to do some homework...
Thanks..
Ron

TheRabbit

http://www.summitracing.com/parts/mrg-7872/overview/

You could wire it to your ignition with a relay.

fla1976

^^^ Good setup.